I simulated a triac dimming circuit according to the book, the power supply voltage is 220vrms, the frequency is 50Hz. Why doesn't the triac not automatically turn off at the voltage zero crossing point? I looked at the discharge waveform of the capacitor and it dropped to 0 after half a cycle. Decrease the power supply frequency to 10Hz and it can be turned on every half cycle. Why? Is it because I use general-purpose component simulation or?
I have never used a triac, I hope you will guide!
Iwan postato su October 29, 2020
There are many reasons for software!
Eren postato su October 29, 2020
Go directly to the board for debugging. Don't simulate.
Armand postato su October 29, 2020
In the simulation, it is obviously wrong to maintain the conduction without turning off after the triac is triggered to conduct for the first time. The reason is that there is a problem with the TRIAC simulation model, do not use it.
Use other suitable simulation models to achieve normal simulation. However, good things are more difficult.
